image

Power Grid Control Using Gsm

image

Hardware Requirements

  • Micro Controller : AT89S52
  • Crystal : 11.0592 MHz
  • Lcd : HD44780
  • Gsm Modem
  • Max232
  • Loads
  • Software Requirements

  • Keil
  • Proteus
  • Uc Flash
  • Embedded C
  • Prog Isp
  • Project ID:90
  • Price: 4500
  • Quantity

    Block Diagram

    image

    PROJECT HIGHLIGHTS

    image

    Easy to use, Self-explanatory kit.

    IMAGE

    All-inclusive solution kit.

    IMAGE

    Extensive audio-visuals available.

    image

    Branding-free material.

    IMAGE

    Call/mail for Tech Support from 10 am - 7 pm.

    IMAGE

    Can be Customized for Arduino, Raspberry Pi, PIC quicker jobs, bpo jobs, seo jobs

    PROJECT DESCRIPTION

    This project is aimed to design a system to control the power grid by using wireless technology called GSM technology. In industries, there will be various loads to be operated and these loads are to be operated at some specific intervals according to our requirements and also based on the device constraints. For these purposes, a person should be employed to monitor the status of the loads. But there may be chances that the person may forget to operate these loads. And also it is not an easy task for a person to operate these loads manually as these loads run with high currents and high power consumption. This project gives the best solution for electrical power wastage. Also the manual operation is completely eliminated. This project is implemented on wireless technology. One of wireless communication system is GSM as it is very cheap and very easy to implement. This project is not only limited to industrial applications but can also be extended to domestic purposes for home appliances controlling using GSM technology. The devices can be switched ON/OFF using GSM technology without actually going near the switch boards or regulators. The loads like lights, motors, heaters, power controlling system and also current through the loads can be controlled in this project. We can control all loads at a time from a remote place without connecting any physical wire between loads and remote place. This project is designed in such a way that a GSM modem is interfaced to the controller through serial port interface, along with the AC devices/loads which are to be controlled by using GSM will be interfaced to the controller through the relays. The GSM modem performs the task of receiving the message from the mobile and sending the messages to the mobile from the controlling unit. If the user wishes to control the devices ON/OFF in industries, he has to send a predefined message to the modem from his mobile. The GSM modem receives this message and intimates the same to the microcontroller. Now it is the job of the controller to switch ON/OFF the corresponding devices in accordance with the received message. A 16X2 LCD will be interfaced to the controller to display the status of the devices. This project uses regulated 5V, 500mA power supply. Unregulated 12V DC is used for relay. 7805 three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac output of secondary of 230/12V step down transformer.